TBSDTV Community Forum

I am using web streaming from a TBS2603 HDMI input (using Astra and HLS.js).

Everything works except iOS, and I think that I need to enable "resample" option to uprate the audio to more than 32k.

The thing is that when I enable "resample" audio stops working, I hear nothing.
I can confirm it because I also tried directly with VLC (http://x.x.x.x:yyy/hdmi)


These are my audio settings:



I tried upgrading from version 1.1.12 to 1.1.96 and it is still the same.

My workardound for now is to disable resampling, but I have to transcode the audio later and I don't want to do that.

Is there anything I can do?

Hi,
Please use Chrome on Windows to upgrade it. and dplease unpack the file, and upgrade the file "update.tar.bz2".

What's your source from, is it samplerate 32000, and you wangt uprate it to 44100?
We have tesed about 48000 resampled to 44100, but not try 32000 to 44100, for 32000 is very seldom using normally.

I mean that I was able to upgrade, but the problem still happens with 1.1.96.

The source is a terrestrial DTV device.
I am not sure the source rate.

I just want it to work with iOS, I am not sure where the problem is.

Hi,
I checked it ok with this config and play in VLC:

Without resampling:
Funny thing is that Audio parameters say that input sample is "48000", but VLC says it is "32000"
But it works (except on iOS).



With resampling:
If I enable resampling then VLC doesn't show any bitrate at all.
In this case it does not work (VLC 3.0.6).

Hi,
Is your aduio encode AAc format?
Please mail to me echo@tbsdtv.com, and maybe we can remote check your device.

Yes it is AAC.

I tried MP3 and it sounds high pitch like a smurf.