TBSDTV Community Forum

I've had that issue also. I'm still running the original firmware so I think the problem has been around since the beginning. Hopefully someone with later firmware will confirm the issue or report that it has been fixed.

Jim

I'll bet that under the molex connector where it is soldered to the board that there are connections without solder. TBS has taken good care of me in the past. I would expect that they would take care of you also when you bring this to their attention.

Jim

There are many who are trying to figure out a reliable way to update a linux system using linux tools and the progress in that direction has been little at best. When it happens, you'll know it.

Jim

NeuerUser Wrote:You need a new u-boot. The included one is faulty. Here you find some hints, howto build one:

http://tbsdtv.com/forum/viewtopic.php?f ... =10#p30842

See also the later post about enabling 2GB RAM.

I'm going to give it a look. It's number 3 on the to do list.

Thanks,
Jim

Hi jowski Do you have configured the u-boot's IP address variable ?maybe our default IP address is not the one you want to use. Thanks Kind Regards steven I did a setenv ipaddr 192.168.19.151, setenv serverip 192.168.19.92, with the tftp server configured properly and working. The stock Matrix u-bo...

NightMare Wrote:What is the ssh logins

root/root

Jim

Is tftp booting possible with the current Matrix U-boot load? I have a tftp server up and running but when I try to ping it from the Matrix at the U-boot prompt, the tftp server isn't found. I suspect that networking isn't available with the current Matrix U-boot load. If I'm wrong, would someone po...

The patch in the previous post was for the older (3.4?) version of tvheadend. For 3.5, here is the patch which I call linuxdvb_lnb.c.patch: --- output/build/tvheadend-v3.5/src/input/mpegts/linuxdvb/linuxdvb_lnb.c.orig 2013-12-25 22:18:51.408749976 -0800 +++ output/build/tvheadend-v3.5/src/input/mpeg...

I have a patch that will add a C-band 5150mHz LOF, ku-band 10750mHz LOF, with a switching frequency of 8000mHz to dvb_satconf.c so those of us in North America with our "almost standard" setup can use an MOI. What I'd like is for TBS to incorporate the patch and release a tvheadend tarball...

I have a system where C-band has an LOF of 5150000kHz, Ku-band has an LOF of 10750000kHz and a 22kHz switch controls which band is selected. Which LNB type do I select? Where in the file system in the file that has the LNB's so that if I need to change something, I can?

Thanks,
Jim