TBSDTV Community Forum

I can't stop the boot sequence
I press all the keys are on my keyboard and nothing happends!

diabloss wrote:yes ... but got stuck at one point and didn't had the time to go further.

I have an UART cable somewhere that might works with Matrix doing a bit of hack.

I only need to connect RX, TX and GND, right?

Would be great to have a latest kernel version in our Matrix

@mijanek but in this way it could be turned off more time because it takes more time to reach 70ºC again. - Is the source code available somewhere? Hi Cjcr Our code is on sourceforge: https://sourceforge.net/p/matrixtv/ Thanks Kind Regards steven Thank you, but I refer to the source code of the fan...

Thank you Steven, I think a I have an IR receiver somewhere
I will check it later.

You will need an UART connection. At lest for me it worked with an cable which i had from an old cubieboard. Then you tried it with Matrix and it works (I refer to cable)? You connected the VCC too? or just gnd, rx, tx? You tried that manual? you're able to boot ubuntu 13.10 and that kernel on Matr...

Hi guys, I'm trying to make it boot a system with Ubuntu 13.10, kernel 3.13 following these instructions http://eewiki.net/display/linuxonarm/i.MX6q+SABRE+Board+for+Smart+Devices I'm able to create the SD card and I have one ready now with all (rootfs, kernel, uboot..), but It can't boot it, only th...

Whats the advantage of openelec over others ? ie why is openelec with xbmx better then openpctv with openelec ? UDL Hi UDL, I suppose is more mature project than OpenPCTV and they are a big community. That's important for this such things ;) . Look at Raspberry Pi ... Also, here are some interest f...

@mijanek but in this way it could be turned off more time because it takes more time to reach 70ºC again.
-
Is the source code available somewhere?

Thank you Steven.

I think the fan is turned off too soon. Seems when it is < 70 degree it stops immediately. That's wrong. It should keep on at least until it reach 60/65 degree for example and then turn off.

This will keep the device in a good temperature for more time

Thats my opinion.

mijanek wrote:Additionaly to the sync problem I am getting also HDMI sync issues (black screen) after certain time it falls out permanently until reboot:

I confirm such problems with 1.0.0.1.

Also, the XBMC UI is a bit slow on a 1080p screen. In a 720p screen is ok (both versions 1.0.0.0/1.)