OpenELEC Beta 4.95.2 and more

[Imrisko]

I need log from serial port with kernel booting. Without this all is just a guess.

Hi vpeter
sorry im not hat good in the linux command pls can you help me ? How do i do the logfile from serial port ? thank you for your help

[bzoli72]

Hi vpeter!

Please send me, how to start installed OpenELEC 5.0.0 from serial console.
setenv parameters, bootm, etc...

Thanks: bzoli72

[vpeter]

Just need to change uEnv.txt (replacing quiet parameter), reinstall, capture log.

[bobopalo]

Yes, I have a same problem. If you don't have revision 1.3 I have one solution. One possibility is that I know send to you my HW (matrix pc revision 1.3) for investigation of mentioned issue.

[vpeter]

Mine v1.3 works just fine. Same as v2.1.

[bzoli72]

Just need to change uEnv.txt (replacing quiet parameter), reinstall, capture log.

Hi vpeter!

I installed OpenELEC 5.0.0. again with modified uenv.txt.
The result has been mounted on page 14.
In Install and start v2.zip.

In start script not double start log.
After first "Starting kernel..." message restart boot sequence.
Write
"U-Boot 2013.10-rc4 (Dec 29 2014 - 11:02:47)


CPU: Freescale i.MX6Q rev1.2 at 792 MHz"... messages again.

After second "Starting kernel..." message TBS2910 freeze.

No keyboard, no mouse, no UART communication.
Only the Samba shared folders available.

bzoli72

[vpeter]

with modified uenv.txt

Post the content of this file.

[bzoli72]

with modified uenv.txt

Post the content of this file.

Code: Select all

mmcargs=setenv bootargs 'boot=/dev/mmcblk0p1 disk=/dev/mmcblk0p2 progress debugging video=mxcfb0:dev=hdmi,[email protected],if=RGB24,bpp=16 dmfc=3'
uenvcmd=if test -n $ethaddr; then true; else setenv ethaddr 1E:ED:19:27:1A:B2; fi

[bzoli72]

Hi vpeter!

In booting process TBS2910 the TV screen also displays a log.
How can I capture the logs from TV? (Or redirect to serial port?)

Thanks bzoli72

[vpeter]

Instead of quiet must be progress debugging console=ttymxc0,115200 - I forgot on console part before. With this 3 parameters we get kernel boot messages shown on console. Sorry for inconvenience.