Moderator Control Panel ]

How to configure mumudvb in push mode ?

How to configure mumudvb in push mode ?

Postby cyclone27 » Fri Jul 07, 2017 12:54 pm

Hello,
How to configure mumudvb in push mode for Xtream-Codes ?
Regards
cyclone27
 
Posts: 7
Joined: Sat Jul 01, 2017 7:59 am

Re: How to configure mumudvb in push mode ?

Postby steven » Fri Jul 07, 2017 4:01 pm

Hi

You need to use mumudvb output http stream then you can upload to xtream-code.

Thanks

Kind Regards

steven
steven
 
Posts: 2239
Joined: Fri Aug 06, 2010 3:23 pm

Re: How to configure mumudvb in push mode ?

Postby cyclone27 » Sat Jul 08, 2017 6:54 am

Hi,
Here is my card0.conf file config. What do i have to modify to send stream to xtream-codes if my url'pasnel is : mypanel.dtdns.net and incoming push port is : 8001 ? I need user and perhaps password ?
Thanks a lot for help.

card=0
freq=546.166
autoconfiguration=full
multicast=0
multicast_ipv4=0
multicast_ipv6=0
unicast=1
ip_http=192.168.1.20
port_http=2000
cyclone27
 
Posts: 7
Joined: Sat Jul 01, 2017 7:59 am


Return to General discussion

Who is online

Users browsing this forum: No registered users and 4 guests