Page 1 of 1
How to configure mumudvb in push mode ?
Posted:
Fri Jul 07, 2017 12:54 pmby cyclone27
Hello,
How to configure mumudvb in push mode for Xtream-Codes ?
Regards
Re: How to configure mumudvb in push mode ?
Posted:
Fri Jul 07, 2017 4:01 pmby steven
Hi
You need to use mumudvb output http stream then you can upload to xtream-code.
Thanks
Kind Regards
steven
Re: How to configure mumudvb in push mode ?
Posted:
Sat Jul 08, 2017 6:54 amby cyclone27
Hi,
Here is my card0.conf file config. What do i have to modify to send stream to xtream-codes if my url'pasnel is : mypanel.dtdns.net and incoming push port is : 8001 ? I need user and perhaps password ?
Thanks a lot for help.
card=0
freq=546.166
autoconfiguration=full
multicast=0
multicast_ipv4=0
multicast_ipv6=0
unicast=1
ip_http=192.168.1.20
port_http=2000