TBSDTV Community Forum

wondering what version of oscam is used now in the matrix box ... i see no informations about oscam version.
asking because i have found patch that can add emu support to almost any version of oscam.

https://github.com/oscam-emu

here is the patch which i was mention.

diabloss wrote:wondering what version of oscam is used now in the matrix box ... i see no informations about oscam version.
asking because i have found patch that can add emu support to almost any version of oscam.

the version inside matrix (1.0.0.2) is oscam - 1.2+r9227
you may check your package version using following command:

Code: Select all

opkg list

I'll check the patch when I'll get the time for it.

Cjcr wrote:Hi @mijanek, looks like there isn't dvb tbs drivers for their devices (like tbs5925 I have got). Can you check it?

Hi Cjcr, i discovered, that in the kernel used by matrixtv project, teher are some prebuild libs for their dvb devices. I took now this one and made new kernel (whith all latest imx patches) so you may try it out, whenever your device gets recognized. By the way I foud out, that I ommitted the WiFi driver too, so thisone should be also included..

I didn't tested it yet, but here is it..

@diabloss, I made new oscam version with your requested patch, so you may try it out. (I can't test it, as i don't use it)

mijanek wrote:

Cjcr wrote:Hi @mijanek, looks like there isn't dvb tbs drivers for their devices (like tbs5925 I have got). Can you check it?

Hi Cjcr, i discovered, that in the kernel used by matrixtv project, teher are some prebuild libs for their dvb devices. I took now this one and made new kernel (whith all latest imx patches) so you may try it out, whenever your device gets recognized. By the way I foud out, that I ommitted the WiFi driver too, so thisone should be also included..

I didn't tested it yet, but here is it..

@diabloss, I made new oscam version with your requested patch, so you may try it out. (I can't test it, as i don't use it)

Oh, thank you @mijanek. I will take a look in a few hours

No luck.

Here 'dmesg' when connect/disconnect USB (I did two times)

Code: Select all

usb 2-1.1: USB disconnect, device number 8
usb 2-1.1: new high speed USB device number 9 using fsl-ehci
usb 2-1.1: USB disconnect, device number 9
usb 2-1.1: new high speed USB device number 10 using fsl-ehci
[[email protected] ~]#

OK, was only try with hope... do you have at least the wifi working again?

Yep oscam working with the patch.
I tried to adapt and boot up the freescale version of openelec...
Need few more days for debug and remove /add different things to the sources.

Did you tried mijanek.?

diabloss wrote:Did you tried mijanek.?

Nope, I'm not interessted in openElec anymore, since I can compile anything I will. When the status of xbmc and VPU/IPU of imx6 will be more stable, it will be nice feature, but now I like the frequent updates where I can decide, what to use

fresh xbmc build (wolfgar e26d58c7bf)