I'm on my second card as it was assumed the first one was faulty.
i currently use a tbs twin tuner and a single tuner in a VM in ESXI. Using PCI Passthrough. Works fine.
I decided to get a cheaper power efficient T20 dell server with quad core xeon.. unfortunately it wasn't compatible with the old cards due to pci 1.0a not being supported on the motherboard..
so i purchased a 6909.. long story short, could not get it working on a standalone machine using the proprietory drivers and on 2 different ESXI servers (home lab type - gaming mb in one, and T20 Dell in the other).. had tbs support remotely connect, and eventually tried the open source drivers.
no luck.. card replaced and now i'm at the same state.
i'm using ubuntu 14.04, fresh install, opensource drivers, and 6909 passedthrough.
i'm getting spam when ubuntu starts saying -
TBSECP3 Driver 0000:0b:00:0: i2c xfer timeout
and lspci/dsmeg
- Code: Select All Code
0b:00.0 Multimedia controller: Device 544d:6178
acoloss@ubuntu1404-blank:~$ dmesg | grep frontend
[ 19.711573] TBSECP3 driver 0000:0b:00.0: TBSECP3 frontend 0 attach failed
[ 19.711596] TBSECP3 driver 0000:0b:00.0: frontend attach failed
[ 27.837837] TBSECP3 driver 0000:0b:00.0: TBSECP3 frontend 1 attach failed
[ 27.838141] TBSECP3 driver 0000:0b:00.0: frontend attach failed
[ 35.964350] TBSECP3 driver 0000:0b:00.0: TBSECP3 frontend 2 attach failed
[ 35.964666] TBSECP3 driver 0000:0b:00.0: frontend attach failed
[ 44.090827] TBSECP3 driver 0000:0b:00.0: TBSECP3 frontend 3 attach failed
[ 44.091143] TBSECP3 driver 0000:0b:00.0: frontend attach failed
[ 52.217401] TBSECP3 driver 0000:0b:00.0: TBSECP3 frontend 4 attach failed
[ 52.217719] TBSECP3 driver 0000:0b:00.0: frontend attach failed
[ 60.311923] TBSECP3 driver 0000:0b:00.0: TBSECP3 frontend 5 attach failed
[ 60.312252] TBSECP3 driver 0000:0b:00.0: frontend attach failed
[ 68.438428] TBSECP3 driver 0000:0b:00.0: TBSECP3 frontend 6 attach failed
[ 68.438717] TBSECP3 driver 0000:0b:00.0: frontend attach failed
[ 76.565048] TBSECP3 driver 0000:0b:00.0: TBSECP3 frontend 7 attach failed
[ 76.565365] TBSECP3 driver 0000:0b:00.0: frontend attach failed
any help greatly appreciated.
The tbs proprietary driver works 1% of the time.. but freezes and neither mode works properly.
ignoring the modes, i will leave it connected to 1 satellite with 4 inputs (quad lnb)..