Moderator Control Panel ]

TBS6909 connections

TBS6909 connections

Postby hsmptg » Mon May 13, 2019 6:40 pm

Hi

I need to connect a TBS6909 to a Sat multiswitch 5/8.
I already have connected to that multiswitch a SAT receiver and a TBS6982 (both working OK).

Can I use TBS6909 in Mode 1 or Mode 2 with the following cable configuration?

Image

Image

My initial attempts were not very successful since I always have a FAIL during the scan process! :(

Any help please?

Regards
hsmptg
 
Posts: 2
Joined: Sun May 12, 2019 5:13 am

Re: TBS6909 connections

Postby crazycat » Tue May 14, 2019 1:10 am

mode 1 - each tuner pairs must be tuned to same pol/band.
for your case better use default mode 0 and you can tune any transponder on each tuner.

P.S. low SR transponeder usual not locked (<10000 Ks).
Last edited by crazycat on Tue May 14, 2019 8:52 am, edited 1 time in total.
crazycat
 
Posts: 463
Joined: Mon Jan 31, 2011 2:46 am
Location: Ukraine, Kharkov

Re: TBS6909 connections

Postby hsmptg » Tue May 14, 2019 6:37 am

Thanks @crazycat
I will try that!
To change to mode 0, I just have to edit the /etc/modprobe.d/mxl58x.conf file with "options mxl58x mode=0", right?
It is enough or I need then to compile the driver again?

Regards
hsmptg
 
Posts: 2
Joined: Sun May 12, 2019 5:13 am

Re: TBS6909 connections

Postby crazycat » Tue May 14, 2019 8:47 am

just edit modprobe config (comment or delete mxl58x options, default mode=0)
crazycat
 
Posts: 463
Joined: Mon Jan 31, 2011 2:46 am
Location: Ukraine, Kharkov


Return to DVB-S2 Octa Tuner PCIe Card TBS6909

Who is online

Users browsing this forum: No registered users and 3 guests