Page 2 of 2
Re: tbs 6903 can not work in DisEQc 1.1？
Posted:
Sat Aug 06, 2016 4:03 amby satesco
Hi liang747,
Have you chosen correctly tbs card from Settings->Hardware? Also have you done the configuration right in the analyzer for switch 1.1,as I showed you in the previous post?As you already know,every (little)detail counts!
Regards
Re: tbs 6903 can not work in DisEQc 1.1？
Posted:
Sat Aug 06, 2016 7:55 amby liang747
Hi satesco，
I make sure configuration right in the analyzer for switch 1.1,because i used Prof8000 and tbs6922 TV card they work fine wite this 8in1out in Diseqc1.1,they can work fine wite 10in1out in Diseqc1.1,but 6903 can to work.6903 can not change LNB it can work only in LNB1.and 6903 can work fine with 4in1out in Diseqc2.0 but 4lnb is not enough for me。
THS!
Re: tbs 6903 can not work in DisEQc 1.1？
Posted:
Sat Aug 06, 2016 11:26 pmby crazycat
Ask transedit developers, your version not know new tbs cards, so not use tbs specific calls for disecq control. Diseqc 1.0 maybe work via some microsoft diseqc interface.
Re: tbs 6903 can not work in DisEQc 1.1？
Posted:
Fri Nov 25, 2016 6:22 amby Rotarum
SOLUTION:DVBViewer CMUV Folder hardware.xml file edit:
Vendor=0 to Vendor=31
Transedit CMUV Folder TransEdit.ini file edit:
Vendor.0=31 and Vendor.1=31
THX to Griga from DVBViewer Support
http://www.dvbviewer.tv/forum/topic/589 ... -probleme/
Re: tbs 6903 can not work in DisEQc 1.1？
Posted:
Sun Jun 25, 2017 4:51 pmby liang747
Ths very much。6903 is work well。