TBSDTV Community Forum

we use a Gopro Hero 3+ and a Replay Prime X
this cameras need a signal from the monitor (in this case the tbs2603) to switch on the HDMI
at the moment the HDMI is off/goes off, if we plug the camera to the TBS2603
if we use a HDMI Splitter, the camera works (get's the information from the monitor)

I think it's the missing EDID information
is there any chance with a updated firmware to get this signal?

Hi,
Maybe you can change the hdmi cables and try again, some old cables not supoort hdmi signal so good.

echomay wrote:Hi,
Maybe you can change the hdmi cables and try again, some old cables not supoort hdmi signal so good.

Tried many different cables
the camera need an edid information, the encoder give not this information
with a Lindy EDID Emulator (32103) , connected to the camera, everything works
so why do rthe encoder not give the EDID information?

Tried it with the new firmware (85)
no success

Hi,
I will check about EDID, please give me your email, if i have a resoult, i will send you, mine is [email protected].