TBSDTV Community Forum

Hi, my firmware version is in the subject.
if you reset the settings, the encoder becomes to be unusable. The message "BFrameNum should be integer in 1-3" appears. That's the end of this encoder. Consequently HDMI main stream settings can't be saved. Have you ever done a basic, very basic test ?

Regards

webmotions Wrote:Hi, my firmware version is in the subject.
if you reset the settings, the encoder becomes to be unusable. The message "BFrameNum should be integer in 1-3" appears. That's the end of this encoder. Consequently HDMI main stream settings can't be saved. Have you ever done a basic, very basic test ?

Regards

Hi,
This message reminds you that you must enter some valuse for "BFrameNum" blank. Your firmware is too olde, the latest is version 1.1.87, we have many improvements in this version, Please try.
Upgrade setps:
1> Unpack the zip file "tbs2603_firmware_v1.1.87.zip"
2> Upload the file "update.tar.bz2"
3> Start to upgrade until it says "upgrade is successful"

Any question please update to me or write to me, my e-mail "daowei@tbsdtv.com".

Thanks

daowei Wrote:

webmotions Wrote:Hi, my firmware version is in the subject.
if you reset the settings, the encoder becomes to be unusable. The message "BFrameNum should be integer in 1-3" appears. That's the end of this encoder. Consequently HDMI main stream settings can't be saved. Have you ever done a basic, very basic test ?

Regards

Hi,
This message reminds you that you must enter some valuse for "BFrameNum" blank. Your firmware is too olde, the latest is version 1.1.87, we have many improvements in this version, Please try.
Upgrade setps:
1> Unpack the zip file "tbs2603_firmware_v1.1.87.zip"
2> Upload the file "update.tar.bz2"
3> Start to upgrade until it says "upgrade is successful"

Any question please update to me or write to me, my e-mail "daowei@tbsdtv.com".

Thanks

Hi,
Again, the new firmware please check my attachment.

Thanks