I use the TBS2603 to stream a H265 encoded RTP Multicast Stream as shown below.
- Code: Select All Code
CAM-A------------| |-------------TBS2603----H265_RTP_MULTICAST
HDMI_Switch----------HDMI_SPLITTER
CAM-B------------| |-------------MONITOR
- HDMI source is provided by 2 headend devices (CAM-A, CAM-B)
- Both devices output diferent HDMI formats (1xLowResolution, 1 x HighResolution)
- Only 1 device is active (either CAM-A OR CAM-B)
- The stream is viewed via VLC on multiple platforms (Linux, Windows, IOS, Android)
Everything works fine until the end user switches between CAM-A and CAM-B, then the following happens:
- Switching devices takes ~2 seconds (observed on MONITOR)
- VLC shows an initial image of the new device (also after the ~2 seconds) and then freezes (other viewers just stop or crash)
- The TBS2603 stops outputting the stream
- The TBS2603 restarts the stream after >40 seconds (VLC continues with the new stream)
Problem: >40 seconds to restart a stream is far too long
Request: What can I do to get this 40 seconds down to as close to 0 seconds as possible
Thanks!