TBSDTV Community Forum

Use BLScan2 mode for blindscan (CS and EBS Pro have option). And update StreamReaderEx to latest version from CrazyScan project site.

Look like MIS/PLS control implemented in driver, but IS IDs detection not work (or not implemented). Ter/Cable tuner init still incorrect, work only after re-init by StreamReaderEx.

Thanks crazycat

I have one more question.
Does tbs 5927 have hardware support / your support in blscan ? I ask because 6522 has no your support in blscan ( crazyscan in streamreader.log does not write hardware support as in eg prof 7301 ).

BLScan supported for 6522, but implemented as emulation via BLScan2 (with small freq range).

P.S. Full info about supported devices and features @ CrazyScan Wiki

crazycat Wrote:BLScan supported for 6522, but implemented as emulation via BLScan2 (with small freq range).

P.S. Full info about supported devices and features @ CrazyScan Wiki

In case of 5927 is also Blscan implemented as emulation via BLScan2 (with small freq range) ?

For all STV091x-based devices implemented both BLScan, BLScan2 and all advanced features like ModInv. TBS 6983, 6903/5/8, 5927.

But be aware that with 5927 you won't have DVB-S2X
Life is cruel

Next DVB-S2X TP on 33,0E

crazycat Wrote:BLScan supported for 6522, but implemented as emulation via BLScan2 (with small freq range).

P.S. Full info about supported devices and features @ CrazyScan Wiki

For 6522, any chance to add full hardware support for blscan but not emulation? Does it depend on Tbs producer ?

One problem. After scanning with Blscan2 , I do not have picture on dvbdream and altdvb and it is back only after restarting computer. I think that blscan 2 blocks signal.

please check latest test build StreamReaderEx-BDA 1.2.4.4000 - http://crazycat69.narod.ru/sattelite/St ... Ex-BDA.rar

Hi All
im using tbs 6522 for few weeks.
i was wondering why it block during blscan2 and then after 30min finish low range with sometimes 100frequency found.

After uncheck blindscan2 i see where problems is:

https://youtu.be/Zpjq4AusQgg

it loops around one frequency and can't scan further

there is any chance to fix it?