tbs 6209 never seen channel

[unottico1965]

hi, I have buy this card for replace the old quad-tuner, only
because I need to record from more of 4 different mux.
from when I have buy this new card, I have never seen 1 dvb-t channel.
what to do ?
i'm angry to have spent 350 euro for see nothing.
i'm ready for send back the card and ask for the money.
thank.

[steven]

Hi

For the 6209 what about the signal input is the loopout signal from 6205 ? please have a try direct put the signal to 6209 check whether is ok

thanks

Kind Regards

steven

[SJGSM]

SAME here , Everything is ok Hardware it is recognized , BUT NO SIGNAL and ZERO CHANNELS AFTER SCAN

I set TBS6209 Change Mode Tool v1.0.0.1 to DVB-T2 write and it recognize it BUT NO CHANNELS FOUND and NO SIGNAL after SCAN

[crazycat]

Maybe need some amplifier ? RF signal splitted btw 8 tuners.

[steven]

SAME here , Everything is ok Hardware it is recognized , BUT NO SIGNAL and ZERO CHANNELS AFTER SCAN

I set TBS6209 Change Mode Tool v1.0.0.1 to DVB-T2 write and it recognize it BUT NO CHANNELS FOUND and NO SIGNAL after SCAN

Hi

we already fixed unottico1965 issue can you send one email to my email steven@tbsdtv.com we will have a remote check where the problem is
as we need more detail information .

Thanks

Kind Regards

steven

[darrensellers]

I have the exact same problem. Tuner can't find any channels dispite knowing the ariel is good.
I tried to contact support but nobody replied.

Is there a fix?

[steven]

Hi darrensellers

We have not get email for you ,can you tell us that which email you send to ? and already send a test driver please have a check
and test whether is good

Thanks

Kind Regards

steven

[darrensellers]

I completed the online support form. I tried the new driver, but still the same. The change mode tool also doesn't work I get the error "QuerySupported KSPROPERTY_BDA_CTRL_DemodMode Error"

[satesco]

I completed the online support form. I tried the new driver, but still the same. The change mode tool also doesn't work I get the error "QuerySupported KSPROPERTY_BDA_CTRL_DemodMode Error"

Here's what you need to do:uninstall the driver and then install it again,as you can see in the picture.Hope to help.
I am using driver version 1.0.0.2 - 27-Dec-16.

[darrensellers]

I uninstalled and reinstalled the driver. The switch tool now works, but the tuner still doesn't find any channels.