Page 1 of 2
Few questions
Posted:
Wed Nov 15, 2017 6:28 am
by TheTroll
Hi,
1) FAN noise
I see that there is a FAN on this board.
Is it noisy ? Can you hear it at all ?
2) Output signal
It was nice on the 6205 to have an output signal to chain the cards...
Why didn't you add it here ? And why did you use this kind of connector instead of the F one ?
Thanks
Re: Few questions
Posted:
Thu Nov 16, 2017 11:23 am
by steven
Hi TheTroll
Thanks for your interest of our product and for your question :
1. normally is ok ,if in a quite place you can hear .
2. As they are using different tuner and demo so for 6209 we have not add the loopout signal
Thanks
Kind Regards
steven
Re: Few questions
Posted:
Fri Nov 17, 2017 5:46 am
by TheTroll
Ok thanks!
Re: Few questions
Posted:
Thu Nov 30, 2017 6:20 pm
by TheTroll
Hi,
another one, could you please confirm if the external power is mandatory ?
I tested the card without it, and it looks like some tuners are stuck in the IOCTLs...
Thank
Re: Few questions
Posted:
Fri Dec 01, 2017 5:57 pm
by TheTroll
Ok I found the issue, it was not due to the power supply.
The card does not like if we open all tuners at the same time, FW loading of all tuners must be done in sequence.
Re: Few questions
Posted:
Tue Dec 05, 2017 4:12 pm
by steven
Hi TheTroll
Thanks for your update ,if the power from PCI-E slot not enough then need the extra power
Kind Regards
steven
Re: Few questions
Posted:
Sat Dec 08, 2018 9:57 pm
by TheTroll
Hi,
I got this board and the FAN makes a lot of noise
Can it work if I unplug it? Will it burn ?
Thanks
Re: Few questions
Posted:
Mon Dec 10, 2018 9:52 am
by steven
TheTroll Wrote:Hi,
I got this board and the FAN makes a lot of noise
Can it work if I unplug it? Will it burn ?
Thanks
What about your temprature enviroment if it is not hot then you can remove the FAN power .make sure the cooling from the server is well
Thanks
Kind Regards
steven
Re: Few questions
Posted:
Mon Dec 10, 2018 9:45 pm
by TheTroll
Ok thanks
Re: Few questions
Posted:
Fri Dec 14, 2018 7:12 pm
by raptorjr
Is it possible to change for another cooling solution? Some different fan or something? I don’t need it to look pretty. Just be quite =)