Moderator Control Panel ]

No signal after resume from standby

Re: No signal after resume from standby

Postby cocoa117 » Wed Nov 07, 2012 11:06 pm

I am running Ubuntu 12.04 64 bit, and I have found same issue as users reported with their Windows OS.

I am running TVheadend server on the machine, and experiencing issue of no signal detected.

I have tried two machines one Dell Dimension 9200, and other self build Intel motherboard DQ35JO. Both of them suffer same issue with suspend/resume (S3) and no signal issue.
cocoa117
 
Posts: 7
Joined: Thu Oct 20, 2011 9:13 pm

Re: No signal after resume from standby

Postby PerryM » Wed Jan 01, 2014 9:05 pm

I have had a long running problem with this card. About 1-2 times out of 10 it does not initialise correctly and I get excessive error rates, usually unusable. This is of course a disaster for scheduled recordings. I use DVBViewer.
I have tried all the supposed cures I could find on this and other forums, but none seemed to make much difference.
Finally in desperation I have purchased a TBS6982 replacement card, and (touch wood) so far after about 20 recordings it is good. I have made no other changes (other than the driver of course) so I think we can make a reasonable conclusion for the source of my previous problems.
FWIW
PerryM
 
Posts: 11
Joined: Thu Feb 16, 2012 5:22 pm

Previous

Return to Windows

Who is online

Users browsing this forum: No registered users and 2 guests

cron