TBSDTV Community Forum

steven Wrote:Hi Derrick

But after my test ,12538 41250 V
LNB is 9750 10600
it is high band
12538-10600 = 1938,
I can use this lock successfull.

So 22k is no problem,i just do not know why you can't?

It doesn't work here either, no matter what I do...

(win 7 64bit)

Hi Derrick and sotos65

would you mind set like this put LNB frequency value with your high band.do not use input setup.

Thanks

steven Wrote:Hi Derrick and sotos65

would you mind set like this put LNB frequency value with your high band.do not use input setup.

Thanks

You must be joking.. I need diseqc! Without setup, no tuning of low band channels from other satellites either. Without setup I can only tune to low band channels of astra 19E which corresponds to the 1. diseqc port. But astra high band transponders are still missing

steven Wrote:Hi Derrick and sotos65

would you mind set like this put LNB frequency value with your high band.do not use input setup.

Thanks

Hi steven.

It doesn't work either with these settings. Actually this was my original setup since I don't have a diseqc switch, only a diseqc 1.2 motor.

Hi Derrick and sotos65

Would you mind try to use the debug driver and use debugview to see the output.when you lock the high band TP.
and save the debugview log file and LNB&Transponder setting information send it to my email steven@turbosight.com.
I will check the driver whether received 22k command.
Here is the file of driver and debugview tool:
http://hotfile.com/dl/128561543/89c72b6 ... g.rar.html
http://hotfile.com/dl/128561526/258fc49 ... w.rar.html

Thanks

Hi Steven, I will try it later...

Btw, please don't use hotfile, or at least don't use just hotfile. I downloaded the 1MB 1.0.1.8 driver and when I tried to download those two Hotfile put me in 26 minutes of waiting because "You reached your hourly traffic limit"! You may try these ones instead, simultaneous uploading to several host sites...

http://www.multiupload.com/
http://www.mirrorcreator.com/

Hi again! I've just tested it with the debug driver + debugview, and indeed the ts reader module just doesn't seem to send the 22KHz tone to the LNB or set the hi band correctly. I uploaded three log files obtained with the debugview tool. Two using TS Reader (one at 10774H where everything is fine, the second at 12168V where it doesn't work) and a third with DVBViewer Pro at 12168V where everything is fine. I hope they are useful to you...

http://www.multiupload.com/BZ7UTRLDAH

..ok, then I don't have to stress my broken card

btw.
there's also a 22KHz bug relating to TBS8921. Only after a 2nd tuning attempt tsreader will tune to high band channels. This was reported by me a long time ago but nothing happened.

With this new driver 1.0.1.8,TSReader can be activated even for high band transponders.I checked it on Astra 3A, 3B-23.5 E-12658 V,2278,5/6:

satesco Wrote:With this new driver 1.0.1.8,TSReader can be activated even for high band transponders.I checked it on Astra 3A, 3B-23.5 E-12658 V,2278,5/6:

Maybe you should edit your post. IMHO the screen shots shows tcp-streaming