TBSDTV Community Forum

Thank you, with this source.dll TSRreader is sending correct diseqc commands

Though, there are some points that still need improvement. Tuning and locking of high band frequencies takes about 15s! The reason is that at the 1st attempt no tone is applied -> failed to lock signal. After retuning a continuous tone is sent but with an additional delay of 3s after the diseqc command.

..just for information: The card/driver shows a memory effect. After (re)starting the source, voltage/tone are the same as from the previous tuning.

Derrick wrote:Thank you, with this source.dll TSRreader is sending correct diseqc commands

Though, there are some points that still need improvement. Tuning and locking of high band frequencies takes about 15s! The reason is that at the 1st attempt no tone is applied -> failed to lock signal. After retuning a continuous tone is sent but with an additional delay of 3s after the diseqc command.

..just for information: The card/driver shows a memory effect. After (re)starting the source, voltage/tone are the same as from the previous tuning.

Really thank you,I am finding the problem too,I will look into it and find out what the problem is.

Derrick wrote:Thank you, with this source.dll TSRreader is sending correct diseqc commands

Though, there are some points that still need improvement. Tuning and locking of high band frequencies takes about 15s! The reason is that at the 1st attempt no tone is applied -> failed to lock signal. After retuning a continuous tone is sent but with an additional delay of 3s after the diseqc command.

..just for information: The card/driver shows a memory effect. After (re)starting the source, voltage/tone are the same as from the previous tuning.

Hi Derrik,
Would you mind to give me your email address,I will give you a debug driver for test!
Really thanks
steven

@steven, please check your pm.