TBSDTV Community Forum

Posted: **Fri Dec 23, 2011 4:04 pm**

I have the same issue with kernel 3.x:

Code: Select all: Dec 23 10:11:14 debian kernel: [ 828.716162] DEBUG: 5922 tune checked Dec 23 10:11:14 debian kernel: [ 828.744274] DEBUG: 5922 tune checked Dec 23 10:11:14 debian kernel: [ 828.772258] DEBUG: 5922 tune checked Dec 23 10:11:14 debian kernel: [ 828.800243] DEBUG: 5922 tune checked Dec 23 10:11:14 debian kernel: [ 828.828227] DEBUG: 5922 tune checked Dec 23 10:11:14 debian kernel: [ 828.856213] DEBUG: 5922 tune checked Dec 23 10:11:14 debian kernel: [ 828.884198] DEBUG: 5922 tune checked Dec 23 10:11:14 debian kernel: [ 828.912185] DEBUG: 5922 tune checked

any solutions?

Posted: **Wed Jan 25, 2012 3:39 pm**

Hello! I have a problem. After rebooting, there is an error in dmesg:

Code: Select all: [49101.456278] TurboSight TBS 6984 Frontend: [49101.456280] tbs6984fe - Current Delivery System and Mode are unknown [49106.456175] TurboSight TBS 6984 Frontend: [49106.456178] tbs6984fe - modulation 6 is not supported

Signal no. But after running scan-s2 signal appears, and everything works.
In dmesg remains only this error:

Code: Select all: [49155.376754] TurboSight TBS 6984 Frontend: [49155.376757] tbs6984fe - modulation 6 is not supported

Last drivers.

P.S. I do not speak English, use a translator.

Can't scan (Kernel 2.6.39-5)