Moderator Control Panel ]

i2c i2c-1 stid135_probe :fe_stdid135_init error 13

News and information about TBS products.

i2c i2c-1 stid135_probe :fe_stdid135_init error 13

Postby nborjas » Fri Oct 28, 2022 8:44 am

Hello Good morning, I have a problem, I can't install the TBS drivers of the 6909 X2 on a dell 320 server, I get an error like the one attached, can someone help me please.
Attachments
errordriver.docx
Foto del error en el servidor al arrancar
(194.48 KiB) Downloaded 111 times
nborjas
 
Posts: 5
Joined: Sat Jan 30, 2021 8:47 am

Re: i2c i2c-1 stid135_probe :fe_stdid135_init error 13

Postby smile » Mon Oct 31, 2022 10:26 am

Hi sir
the error show the card's i2c error, cannot communicate with the chip.
Do you have try it with other pc? is it working?

Best Regards
smile
 
Posts: 164
Joined: Sun Oct 09, 2011 9:51 am

Re: i2c i2c-1 stid135_probe :fe_stdid135_init error 13

Postby nborjas » Wed Nov 02, 2022 12:25 am

We will not try it on another PC yet, I tell you.

Thank you very much.
nborjas
 
Posts: 5
Joined: Sat Jan 30, 2021 8:47 am

Re: i2c i2c-1 stid135_probe :fe_stdid135_init error 13

Postby nborjas » Wed Nov 02, 2022 1:27 am

Hello, it was installed on another server and it comes out the same, it recognizes the card but it throws the same error.

if you look recognize the card.

01:00.0 Multimedia controller: TBS Technologies DVB-S2 4 Tuner PCIe Card
nborjas
 
Posts: 5
Joined: Sat Jan 30, 2021 8:47 am

Re: i2c i2c-1 stid135_probe :fe_stdid135_init error 13

Postby smile » Wed Nov 02, 2022 9:41 am

Hi
Could you try this way:
ctreat a config file<tbsecp3.conf> on /ect/modprobe.d

input: options tbsecp3 enable_msi=0

save it , then reboot the server.

Best Regards
smile
 
Posts: 164
Joined: Sun Oct 09, 2011 9:51 am


Return to News

Who is online

Users browsing this forum: No registered users and 4 guests