Paust55 Wrote:I'll answer myself, because I found a solution for use my remote control with "serial_ir" instead of my old "lirc_serial"
1. In
/etc/modprobe.d I added a new file called "
serial_ir.conf" with this content:
#COM1 equivalent, /dev/ttyS0
options serial_ir irq=4 io=0x3f8
2. In
/etc/lirc I changed the file "
hardware.conf" and replace "lirc_serial" with "serial_ir" :
...
REMOTE_MODULES="lirc_dev serial_ir"
REMOTE_DEVICE="/dev/lirc0"
...
After a reboot I can now use my remote control and all things work perfect!
I used an needed the new open sorce driver with my new TBS-6205 to receive DVB-C and DVB-T2 with on driver at the samt time!
Very good work from your team!
Paul
Can you explain how you can get dvb-c and dvb-t, on tbs6205 at same time?
I did that, using osource drivers, and work, but the signal is very week, this card as only one input, so i had to combine both modulations on same input.
Is thare any chance to have this working 100% on this way? I can only have on card on this system.
In the past i used one 6205 in dvbc and 6281 in dvbt and every thing worked perfercly, but on this system can only have one card.
Is thare any way to modify the card to use rf out as rf in??