Dear Friends,
I am new to the DVB card world. I am using TBS 5990 for the past one week only. I am facing a problem while doing blind scan. I have 4 dish setup and a total of 8 LNBs (one of them is monoblock LNB).
I am using Diseqc 1.1 (8x1) and 1.0 (4x1 - actually 2.0) switches in my setup.
Monoblock LNB is connected to port 1 of 8x1 switch.
5 more LNBs are also connected to port 2 till port 6 of 8x1 switch.
2 other LNBs are connected to port 1 and port 2 of the 4x1 switch. The output of 4x1 switch is connected to port 7 of 8x1 switch.
All blind scans are working fine if I am selecting the desired ports for Diseqc 1.1 except when I am selecting port 7 for which I am also selecting Diseqc 1.0 ports.
The monoblock LNB which has built-in Diseqc 1.0 is also working fine if I am selecting port 1 for 1.1 and port 1/2 for Diseqc 1.0.
Problem-1:
But I don't know why it is not working when I am selecting port 7 of 1.1 and port 1/2 of 1.0.
Particularly when I am selecting port 2 for 1.0 switch, it is reading from that port only for one polarization. When it start scanning other polarization, the port is getting moved to port 1 automatically.
But the above said problem is not happening when I am selecting port 1 for 1.1 and port 2 for 1.0 which is actually built-in Diseqc 1.0 of monoblock.
I am using EBS Blind Scan version 4.3.
Replaced the StreamReader.dll with latest one from the below link.
http://crazycat69.narod.ru/sattelite/St ... Ex-BDA.rar
Whether the version 2.0 of the switch is the problem?
But the same setup is working perfectly when I am connecting with DVB Dream and in my existing set top box.
Problem-2:
Also, when I completed scanning by selecting port 7 for 1.1 and port 1 for 1.0, if I am selecting another satellite profile which is also from port 1 of 1.1 but port 2 of 1.0, the card is still reading from port 1 of 1.0 though the commands are sent correctly in the logs.
Please help me to fix this since I am not able to use the device efficiently.
Not sure if it is the problem with the device.
I contacted CrazyScan support as well. They are also suspecting it to be a hardware issue.
Thanks,
Sadiq