Nenya Wrote:Today TBS team released new version of TBS BS Tool (3.0.0.2) but this version has the same error as previous release.
paulus Wrote:It appears the problem is still there.
My setup consists of the QBox 3 connected to a 4 port diseqc.
Port A is a stationary Cband dish.
Port B is a motorized KU dish with a standard linear LNB and SG2100.
This setup works flawlessly in Smart DVB. I should note that navigating to "Tools" menu then "Device settings" and selecting "Prof tuners" as the "diseqc mode" for the bda device settings, is the only setting I was able to use to get the setup switching properly within Smart DVB.
I downloaded the new Blind Scan program provided in the link above.
I disconnected my Cband dish from diseqc switch and left the KU dish connected to port B in order to simplify the test.
When I scan either H or V polarities with the diseqc set to port B, I obtain 0 results.
I physically disconnected the switch from my setup and set the diseqc to Null in the settings.
Now when I perform a scan, I receive 13 V transponders and 12 H transponders.
The only difference between the scans is the physical removal of the diseqc switch and setting the Blind scan program to Null to reflect this change.
As a side note, If I run a scan with the disecq swtich, the program set to "port B" and polarity set to "All" instead of either H or V, I receive a popup message at the end of the first polarity scan that says "don't support this interface".
If I run the scan with no diseqc switch, the setting set to "Null", and the polarity set to "ALL", the scan will not complete until you press the StopBS button.
steven Wrote:...
here is the driver link for 6921 x86 xp driver:http://hotfile.com/dl/116356707/91f0655/TBS6921_2.0.0.7.rar.html
...
tikimune Wrote:steven Wrote:...
here is the driver link for 6921 x86 xp driver:http://hotfile.com/dl/116356707/91f0655/TBS6921_2.0.0.7.rar.html
...
Hi steven,
does this driver version also fixes the standby bug on the TBS6921 and is it available as x64 version?
steven Wrote:Hi tikimune
this driver solved BlindScan tool send diseqc problem and
x64 dirver maybe wait fews day,abou the standby bug i do not know why some computer is ok other is not,have you try to update your mainboard BIOS.
Thanks
Users browsing this forum: No registered users and 9 guests