[ Moderator Control Panel ]
by sparkey1000 » Sat Feb 13, 2016 5:16 am
Does anyone have the SW6 4 position switch settings for the TBS 2910 V2.3.
I am trying to boot from an SD card.
-
sparkey1000
-
- Posts: 17
- Joined: Wed Jan 20, 2016 9:58 am
-
by vpeter » Sat Feb 13, 2016 4:23 pm
I will be little malicious but you can have only 16 combinations with 4 pin dip switch right? So try one by one - it is few minutes work
You can help me buy new work notebook with paypal donation, after 8 years it's time to upgrade.
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=FLVT7ACMYAPS6
-
vpeter
-
- Posts: 427
- Joined: Sun Jul 27, 2014 2:12 am
- Location: Slovenia
-
by sparkey1000 » Sun Feb 14, 2016 4:26 am
I thought of that. However, this 4 position switch may be used by the factory to load firmware into various sections of the unit. Some switch combination could result in the corrupting of an internal firmware load and turn this computer into a BRICK. Best to know what the 2^4 =16 switch combinations do before messing with them.
Regards
Sparkey1000
-
sparkey1000
-
- Posts: 17
- Joined: Wed Jan 20, 2016 9:58 am
-
by sparkey1000 » Sun Feb 14, 2016 4:29 am
I have a request into technical support for the schematic. They stated they are on holiday for a week and will get back to me after. We will see.
-
sparkey1000
-
- Posts: 17
- Joined: Wed Jan 20, 2016 9:58 am
-
Return to Install and setup
Users browsing this forum: No registered users and 2 guests