Warning! Do not use this tool !!! After playing for a while with recorder 3.0.0.7 and driver 1.0.1.7 my 5925 card was completely dead. Pulling the usb- and/or supply-plug didn't help. Down to driver 1.0.1.6 didn't help either. Frustrated I've shut down everything and went for a walk. When I came ba...
confirmed! Just installed new driver and recorder 3.0.0.7 for my 5925. PLS can be set correctly -> lock, but for MIS the input streams can't be identified -> 0
..I've made a mistake. It should read that the 1st 8 bytes are swapped -> in pid stream 0x0200 one ts_packet is missing and in pid stream 0x0203 there is one ts_packet (with wrong payload) too many.
byte 0 is always 0x47 and byte 1 on this mux is the same for PID 0x200 and 0x203. Apparently as you wrote the 1st byte is swapped. Could you check this with windows as well?
I'm not a regular visitor on this board any more, but from time to time I check for new posts. Alas the majority of the new post are reports about feeds which are of course obsolete when I read them. The more interesting topics about new drivers etc are easily lost in feed-noise.