TBSDTV Community Forum

Did you ever find a solution to your problem with the 8922? Not yet. I picked up some RAM for a few dollars to get the last motherboard I haven't tested with the 8922 running again, but I haven't had a chance to test anything yet. TBS support still isn't responding to e-mails and are obviously igno...

I normally use my TBS 8922 in my Intel chipset equipped machine but after reading your post I tried it in an older spare machine I have here with VIA8237 chips. The driver (1.0.1.5) installed no problem, the card shows up under sound video and game controllers in Control Panel. No freezing. Windows...

Other posts on the board are being answered, but this one has been ignored. I also contacted support directly by e-mail about this issue and nobody has responded. If this issue is being checked on and it will take a while then that's fine. I would just appreciate some kind of response. Either this i...

Well, the TBS8922 PCI card I purchased has arrived and there's a major problem. I had to try the card in three different computers before I found one that it would install on without freezing the machine. Two of the computers completely lock up when setup gets to tbs8922.sys. The third computer allo...

starman345 Wrote:In case you don't know, CrazyCats' streamreaderEx proxy source module works very well from the command line in TSReader with many cards, including the 8922

Thanks, I wasn't aware of that. I'll certainly give it a try if things don't work out with the official source module.

steven,

Thank you for the reply. Unfortunately, you didn't answer my question. I know that command line isn't supported now. I asked if you could make the TSReader_BDASource source code available so I could add support for it. I would appreciate it if you could answer that question.

Thank you.

Hi. I've purchased a TBS8922 card and would like to be able to start TSReader from a command line. Can you please consider making the source code available for TSReader_BDASource_TBS8922.dll? I would like to add command line support to the code myself since it isn't supported yet. Thank you.