signal problem ..

[cody]

ok, please, try with this driver:

http://rapidshare.com/files/400584144/T ... p.rar.html

and tell me if there is an improvement.

[crsmoro]

exactly the same..
can get signal from 10974 to 11130 (sometimes to 11170) ..
after that, nothing ..

[cody]

according to: http://www.lyngsat.com/staronec2.html

symbol rate is 29890 and not 29900 - it's very small difference and i doubt it will make any difference and help, but please try with 29890 kSps.

if that didn't help, i believe it's better to send your card back to us for further diagnostics and investigation. so, please, also send an e-mail to euro_support@tbsdtv.com to discuss the details.

[crsmoro]

i already do that ..
look my print ..
viewtopic.php?f=11&t=36#p172

[crsmoro]

more info, see if it can help..

well, after you send me that driver 1.0.4.1 and a several times of scaning and scaning again and again o get signal from others TPs BUT, only for a few minutes, sometimes seconds, when they get signal Q=~80% for DVB-S TPs and DVB-S2's Q=~80% for 12160 V, Q=~50% for 12020 V these two are really unstable, signal come and go thounsands times in less than a minute ...
and because of that (i guess) any program stop working and win closes it ..

THEN

i install the newest driver again (1.0.5.3) to see if really was it (hoping to be something on driver), but for my surprise still working how a described above ..
**yes, rebooted my pc many times

now, the curiosity ..

when the 8920 tunes TPs > 11170 V takes more time to tunning back TPs < 11170 (when it works at first, otherwise i have to selecting several times TPs < 11170 to get work) and vice-versa ...


now u tell me, back maybe to the driver problem ??

[crsmoro]

good news, finally ..
look


i just switch pci ..
but its really weird cuz i already have my another dvb-s board on that pci ..
look the levels too, raised just because i switch the pci ??? you see any logic ??


i will test for a while see if it really fixed ..

[cody]

it's good that you found a solution for the problem. i believe the only possible explanation for the problem is that your other PCI slot doesn't provide enough power for TBS 8920 to work good.