Hi..
I want to buy this box.. USB DVB-S2 QBOX II
But this BOX support all this?
Direct input of one or more MPEG-2 Transport Streams (TS). MPEG-TS is supported using a compatibility mode.
* The native stream format for DVB-S2 is called Generic Stream (GS), and can be used to efficiently carry IP-based data, including MPEG-4 AVC/H.264 services.
* Backward compatibility to DVB-S, intended for end users, and DVB-DSNG, used for backhauls and electronic news gathering.
* Variable coding and modulation (VCM) to optimize bandwidth utilization based on the priority of the input data, e.g., SDTV could be delivered using a more robust setting than the corresponding HDTV service.
* Adaptive coding and modulation (ACM) to allow flexibly adapting transmission parameters to the reception conditions of terminals, e.g., switching to a lower code rate during fading.
* Four modulation modes:
o QPSK and 8PSK are proposed for broadcast applications, and can be used in non-linear transponders driven near to saturation.
o 16APSK and 32APSK are used mainly for professional, semi-linear applications, but can also used for broadcasting though they require a higher level of available C/N and an adoption of advanced pre-distortion methods in the uplink station in order to minimize the effect of transponder linearity.
* Improved rolloff: a = 0.20 and a = 0.25 in addition to the roll-off of DVB-S a = 0.35.
* Improved coding: a modern large LDPC code is concatenated with an outer BCH code to achieve quasi-error free (QEF) reception conditions on an AWGN channel.
The outer code is introduced to avoid error floors at low bit-error rates.
A single FEC frame may have either 64800 bits (normal) or 16200 bits (short). If VCM or ACM is used, the broadcast can be a combination of normal and short frames.
* Several code rates for flexible configuration of transmission parameters: 1/4, 1/3, 2/5, 1/2, 3/5, 2/3, 3/4, 4/5, 5/6, 8/9, and 9/10. Code rates 1/4, 1/3, and 2/5 have been introduced for exceptionally poor reception conditions in combination with QPSK modulation. Encoding values 8/9 and 9/10 behave poorly under marginal link conditions (where the signal level is below the noise level).
However, with targeted spot Ku or Ka band downlinks these code rates may be recommended to prevent out-of-region viewing for copyright or cultural reasons.
Tank you very much...