by stilmant » Wed Dec 16, 2015 4:10 pm
No I did not found a real solution, my chance are that affected computers are not used from main UI when installed. When I need to use main UI, I disconnect the IR input device:
In case of TBS tuner sending IR code leading in unexpected arrow UP key pressed:
1) Execute the command xinput list to list your input devices.
2) Locate AT Translated Set 2 keyboard and take note of its id number; this will be used to disable the keyboard. Also, take note of the number at the end, [slave keyboard (#)]; this is the id number of the master, which will be used to re-enable your keyboard.
3) To disable the keyboard, execute the command xinput float <id#>, where <id#> is your keyboard's id number. For example, if the id was 10, then the command would be xinput float 10.
4) To re-enable the keyboard, execute the command xinput reattach <id#> <master#>, where master is that second number we noted down. So if the number was 3, you would do xinput reattach 10 3.
> xinput list
IR-receiver inside an USB DVB receiver id=14 [slave keyboard (3)]
> xinput float 14