Hello All,
The firmware for MOI has been updated to V2.0 with the following improvments:
A RS232 serial cable and a micro SD card are necessary for this update, please make sure those things are ready before you get started.
All of your settings before the update can NOT be saved, and you might need to change the IP again if your IP is not in the same IP range with MOI, please refer to the user manual for more information about IP settings.
What’s new in V2.0:
1). Add VDR support.
VDR provides a more convenient way to receive & watch encrypted TV channels, because it enables dynamic loading of CAM.
2). Add telnet protocol for remote access to MOI.
login: root
pass: tbs
3).Satellite list has been updated, the number of satellites increases from 94 to 154.
How to update:
1).Connect RS232 serial cable & install software.
Connect one end of the RS232 cable to MOI, the other end to your PC, install the software:
- for Windows users: TTERMPRO
- for Linux users: minicom
NOTE:
a.the software mentioned above is only for reference, you can use other software as well.
b.uClibc has been changed to EGLIBC.
2).Update through micro SD card*
Prepare a formatted micro SD card, copy the file “MOI290-fs.bin” into it, insert it into the SD card slot on MOI, power on MOI, “Enter” uboot quickly (within about 3 seconds after MOI is powered on) and input the command lines:
setenv loadmmcfs 'fatload mmc 0:1 40000000 MOI2900_fs.bin'
setenv updatekfs 'nand erase 50c0000;nand write.yaffs 40000000 50c0000 ${filesize}'
save
then input “re”, MOI will start to update.
* Update through USB stick is not supported for this version.
More about VDR* support
VDR provides a more convenient way to receive & watch encrypted TV channels, because it enables dynamic loading of CAM.
1).vdradmin support
With VDR running, input MOI IP:8001 in the address bar, for example, if your MOI IP address is 192.168.1.188, then input 192.168.1.188:8001, the user name and password are both tbs. On this site, you will be able to view the EPG information, however, other settings are not supported at the moment.
2).How to use XBMC to connect VDR
With VDR running, start vnsiserver (default port: 34890) and xvdr client.
Please make sure to install vnsiserver4 or xvdr-plugin before you try to connect VDR.
The plug-ins are available to download from the links below:
vnsi
xvdr
3).How to watch TV channels via VLC
Start VLC, and then enter the URL below in “Media” -- “Open Network Stream” --“Network”
http://MOIIP:3000/TS/1
for example, if your MOI IP address is 192.168.1.188, you should enter
http://192.168.1.188:300/TS/1
*More about VDR, please refer to http://www.tvdr.de/
Download the new firmware V2.0