After upgrading my MOI Box with latest release of Firmware 1.2.1, each time when I start MuMuDVB 1.7.1 on MOI I have segmentation fault. Does anybody have any kind of solution, because this is really annoying
Here is my log:
- Code: Select All Code
# mumudvb -d -c /home/mumudvb/Tuner2-HotBird.conf
MuMuDVB Version 1.7.1
--- Build information ---
Built with CAM support.
Built without transcoding support.
Built with ATSC support.
Built with ATSC long channel names support.
Built with support for DVB API Version 5.
---------
Originally based on dvbstream 0.6 by (C) Dave Chapman 2001-2004
Released under the GPL.
Latest version available from http://mumudvb.braice.net/
Project from the cr@ns (http://www.crans.org)
by Brice DUBOST (mumudvb@braice.net)
Info: Main: Full autoconfiguration, we activate SAP announces. if you want to deactivate them see the README.
Info: Main: Full autoconfiguration, we activate PAT rewritting. if you want to deactivate it see the README.
Info: Main: Full autoconfiguration, we activate SDT rewritting. if you want to deactivate it see the README.
Info: Main: Full autoconfiguration, we activate sorting of the EIT PID. if you want to deactivate it see the README.
Info: Main: ========== End of configuration, MuMuDVB version 1.7.1 is starting ==========
Info: Autoconf: The autoconfiguration auto update is enabled. If you want to disable it put "autoconf_pid_update=0" in your config file.
Info: Main: Streaming. Freq 12596000
Info: Tune: Using DVB card "TurboSight TBS 2991 DVBS/S2 frontend" tuner 0
Info: Tune: Tuning DVB-S to Freq: 1996000 kHz, LO frequency 10600000 kHz Pol:V Srate=27500000, LNB number: 4
Info: Tune: LNB voltage 13V
Info: Tune: DISEQC SETTING SUCCEDED
Info: Tune: FE_STATUS:
Info: Tune: FE_STATUS:
Info: Tune: FE_HAS_SIGNAL : found something above the noise level
Info: Tune: FE_HAS_CARRIER : found a DVB signal
Info: Tune: FE_HAS_VITERBI : FEC is stable
Info: Tune: FE_HAS_SYNC : found sync bytes
Info: Tune: FE_HAS_LOCK : everything's working...
Info: Tune: Event: Frequency: 12596000 (or 8604000)
Info: Tune: SymbolRate: 2848000
Info: Tune: FEC_inner: 2
Info: Tune: Bit error rate: 67108863
Info: Tune: Signal strength: 33975
Info: Tune: SNR: 4369
Info: Tune: FE_STATUS:
Info: Tune: FE_HAS_SIGNAL : found something above the noise level
Info: Tune: FE_HAS_CARRIER : found a DVB signal
Info: Tune: FE_HAS_VITERBI : FEC is stable
Info: Tune: FE_HAS_SYNC : found sync bytes
Info: Tune: FE_HAS_LOCK : everything's working...
Info: Main: Card 1, tuner 0 tuned
Info: Autoconf: Autoconfiguration Start
Segmentation fault
#