by LSD » Fri Dec 05, 2014 5:40 pm
[ 2.110722] fec 2188000.ethernet eth0: registered PHC device 0
[ 6.877736] fec 2188000.ethernet eth0: Freescale FEC PHY driver [Generic PHY] (mii_bus:phy_addr=2188000.ethernet:04, irq=-1)
[ 6.877985] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 27.945795] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
so 20 seconds from trying until succeding, seems like a auto neg. problem, will try with a forced 100mbit port which is, as long as I don't get pci-e working, not a problem.
Thank you for the link to your PR, I'll play with it over the weekend. There is a general problem with pci-e or just the lack of HW for you to try it out? If it's the missing HW, I should have some mini-pcie card which I could send you. If it's not a general problem with eg the pci-e bridge, could you enable below settings in the kernel konfig of one of your future images (as I might need more time to get familiar with the build system for imx than you)?
Under Networking Support --> Wireless
CFG80211_CERTIFICATION_ONUS [=y]
CFG80211_REG_RELAX_NO_IR [=y]
under Device Drivers --> Network device support --> Wireless LAN --> Atheros Wireless Cards
ATH_REG_DYNAMIC_USER_REG_HINTS [=y]
ATH_REG_DYNAMIC_USER_CERT_TESTING [=y]
ATH9K [=m]
ATH9K_PCI [=y]
ATH9K_DFS_CERTIFIED [=y]