OpenELEC 5.0.4

[vpeter]

But the blue LED flashes.
Cooling fan not working.

Are you using official version? Because it's not everything there for matrix. Like LED and fan.

And until everything will be merged (this) it will stay like this - I will not provide any more my custom builds because this situation is just stupid. I invested my time in this for nothing it seems.

[Cjcr]

Hi,

Any idea why this happens? It happened after a power cut and never go back. The problem is resolved if reinstall the image ... there's any other way?

[vpeter]

The problem is resolved if reinstall the image ... there's any other way?

I think calling MfgTool2-update.bat should help - it only copies KERNEL and SYSTEM file without formatting the system.

[Cjcr]

The problem is resolved if reinstall the image ... there's any other way?

I think calling MfgTool2-update.bat should help - it only copies KERNEL and SYSTEM file without formatting the system.

Doesn't help just reinstall.

[bzoli72]

Hi,

Any idea why this happens? It happened after a power cut and never go back. The problem is resolved if reinstall the image ... there's any other way?

photo_2015-03-28_16-11-13.jpg

Hi CjCr!

Unplug the SD card or any usb drive and reboot the TBS2910.

bzoli72

[Cjcr]

Hi,

Any idea why this happens? It happened after a power cut and never go back. The problem is resolved if reinstall the image ... there's any other way?

photo_2015-03-28_16-11-13.jpg

Hi CjCr!

Unplug the SD card or any usb drive and reboot the TBS2910.

bzoli72

Hi bzoli72,

I did it and doesn't help.
The blue led keeps blinking and doesn't load Kodi. I also tried to unplug hdmi and all usb. Still the same thing. Just reinstall seems to fix the problem

[PeterB]

Hi,

Any idea why this happens? It happened after a power cut and never go back. The problem is resolved if reinstall the image ... there's any other way?

I've just had this happen to one of my units after power cut last night. Not had time to investigate yet. If re-instating the KERNEL and SYSTEM files doesn't help, then one of the other files must have become corrupted.

Edit:
Magically, two days (and three power cuts) later, the problem went away!

[dubaisatshop]

Can use Cubox-i Openelec image on Matrix?

[Kohai]

Hi

I installed the new openelec and now I cannot find the passthrough function... was that one cut?

Thanks for the answer,
cheers
Kohai

[Dragonway]

Hello,
good job for this version! I update the release to openelec panel config to 5.0.8
I try the codec h265 but it's very slow... possible improvement ?