vpeter Wrote:For fan create a file /storage/.config/imx6-soc-fan-monitor.conf. There should already be sample file named imx6-soc-fan-monitor.conf.sample. Change the values and change high value to 60 for example. Then fan will start at 60 degrees celsius (140F).
Wifi adapter: I assume same as for RPi. Something with Linux support.
cp /usr/config/imx6-soc-fan-monitor.conf.sample /storage/.config/imx6-soc-fan-monitor.conf
#
# imx6-soc-fan-monitor.conf.sample - i.MX6 SoC fan monitor config file
# used only for TBS Matrix system
#
# default limits without config file
# when fan is turned on
# high=70
# when fan is turned off
# low=60
# temperature checking interval
# interval=30
# periodically show temperature
# debug=no
high=70
low=55
interval=30
debug=no
vpeter Wrote:In ssh console run
- Code: Select All Code
cp /usr/config/imx6-soc-fan-monitor.conf.sample /storage/.config/imx6-soc-fan-monitor.conf
Or create it in Windows over samba. The content is
- Code: Select All Code
#
# imx6-soc-fan-monitor.conf.sample - i.MX6 SoC fan monitor config file
# used only for TBS Matrix system
#
# default limits without config file
# when fan is turned on
# high=70
# when fan is turned off
# low=60
# temperature checking interval
# interval=30
# periodically show temperature
# debug=no
high=70
low=55
interval=30
debug=no
echo "echo default-on > /sys/class/leds/fan/trigger" >>/storage/.config/autostart.sh
systemctl restart imx6-soc-fan-monitor
vpeter Wrote:Don't use trigger directly. Instead put in autostart.sh this command
- Code: Select All Code
systemctl restart imx6-soc-fan-monitor
It should already be start by default but there are some timing issues. Will be fixed in next version.
/storage/.config/imx6-soc-fan-monitor.conf
Users browsing this forum: No registered users and 1 guest