I have the TBS5520 and test cross compile for mipsel kernel 4.01
i have use 3 patches from git
https://github.com/ljalves/linux_media/ ... 147b23518a
https://github.com/ljalves/linux_media/ ... 5e3bf20ece
https://github.com/ljalves/linux_media/ ... eac083ac0d
config and compile works fine without any issues
download firmware from here:
https://download.cnx-software.com/publi ... c&download
after load i see this in demsg and tuner not working
usb 1-1: new high-speed USB device number 27 using ehci-brcm
dvb-usb: found a 'TBS 5520 USB2.0' in cold state, will try to load a firmware
dvb-usb: downloading firmware from file 'dvb-usb-tbs5520-01.fw'
tbs5520: start downloading tbs5520 firmware
tbs5520: end downloading tbs5520 firmware
dvb-usb: found a 'TBS 5520 USB2.0' in warm state.
dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
DVB: registering new adapter (TBS 5520 USB2.0)
dvb-usb: MAC address: 00:00:00:00:00:00
i2c i2c-7: avl6882: attach failed family id mismatch
TBS5520: frontend attach failed
dvb-usb: no frontend was attached by 'TBS 5520 USB2.0'
input: IR-receiver inside an USB DVB receiver as /devices/platform/ehci-brcm.0/usb1/1-1/input/input28
dvb-usb: schedule remote query interval to 150 msecs.
dvb-usb: TBS 5520 USB2.0 successfully initialized and connected.
usb 1-1: USB disconnect, device number 27
dvb-usb: TBS 5520 USB2.0 successfully deinitialized and disconnected.
lsmod
Module Size Used by
r848 26002 0
ipv6 383164 55
avl6882 19166 0
dvb_usb_tbs5520 6458 0
dvb_usb 17786 1 dvb_usb_tbs5520
boxmodel 868 0
xfs 690422 0
libcrc32c 714 1 xfs
hd2400 8849929 4
hd2400_3 32993 1 hd2400
hd2400_2 22287 0
hd2400_1 6541 3 hd2400_2,hd2400_3,hd2400
any idea thats wrong
MAC address: 00:00:00:00:00:00 not show correct infos
and
i2c i2c-7: avl6882: attach failed family id mismatch
close source drivers cant be use we use mipsel and arm soc
thx for help
Captain